Pyramix 6.2 SP2 Manuel de service télécharger pdf (Page 18)

System Information

To enable the chkconfig flag for IB drivers on a Linux workstation:

1. Open a shell and log in as root.

2. Start the InfiniBand configuration utility. Type:

/sbin/iba_config

The InfiniBand configuration utility menu appears:

SilverStorm Technologies Inc. InfiniBand 3.2.0.2.1G Software

1) Show Installed Software

2) Reconfigure IP over IB

3) Reconfigure Driver Autostart

4) Update HCA Firmware

5) Generate Supporting Information for Problem Report

6) Host Setup via Fast Fabric

7) Host Admin via Fast Fabric

8) Chassis Admin via Fast Fabric

9) Uninstall Software

X) Exit

3. Open the Reconfigure Driver Autostart menu. Type:

4. When you have completed the configuration, exit the InfiniBand configuration utility. Type:

5. You must restart your workstation for your changes to take effect.

After rebooting, launch the InfiniBand configuration utility again to configure IP over IB.

To configure the IP address and netmask of your IB Interface:

1. Open the Reconfigure IP over IB menu. Type:

2. Follow the on-screen instructions to configure the IP address and netmask of your

Infiniband Interface.

You return to the main menu when you have completed the configuration of the IP address.

3. When you have completed the configuration, exit the InfiniBand configuration utility. Type:

4. You must restart your workstation for your changes to take effect.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 37 38

Pas de commentaire

Pyramix 6.2 SP2 Manuel de service Page 18